LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - Off Vehicle - 1 Of 3) >> Starter Removal

Starter Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: ECT Sensor
    GM1346202Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine coolant temperature (ECT) sensor from the rear of the right cylinder head.
    2. Fig 2: Knock & Crankshaft Position Sensor Wiring Harness Bolt
    GM928184Courtesy of GENERAL MOTORS CORP.
  2. Remove the knock and crankshaft position sensor wiring harness bolt (1).
  3. Disconnect the knock and crankshaft position sensor wiring harness connectors from the knock sensors and the crankshaft position sensor.
  4. Disconnect the knock and crankshaft position sensor wiring harness from the attaching points in the center, back and front of block valley.
    5. Fig 3: Knock & Crankshaft Position Sensor Wiring Harness
    GM928189Courtesy of GENERAL MOTORS CORP.
  5. Remove the knock and crankshaft position sensor wiring harness.
    6. Fig 4: Knock Sensors & Bolts
    GM928196Courtesy of GENERAL MOTORS CORP.
  6. Loosen the knock sensor bolts.
  7. Remove the knock sensors.
    8. Fig 5: Crankshaft Position Sensor & Bolt
    GM928205Courtesy of GENERAL MOTORS CORP.
  8. Remove the crankshaft position sensor bolt.
  9. Remove the crankshaft position sensor.
    10. Fig 6: Crankshaft Position Sensor & O-Ring
    GM1761746Courtesy of GENERAL MOTORS CORP.
  10. Remove and discard the crankshaft position sensor O-ring.
    11. Fig 7: Starter Motor, Wiring Harness & Bolts
    GM928212Courtesy of GENERAL MOTORS CORP.
  11. Remove the starter motor bolts.
  12. Remove the starter motor and starter motor wiring harness.
scientia non olet · About LEMON Manuals