Secondary Camshaft Intermediate Drive Chain Removal - Right Side

WARNING: This page is about a different variant/trim than selected.

Fig 1: Right Secondary Camshaft Drive Chain Tensioner & Bolts

Courtesy of GENERAL MOTORS CORP.

Fig 2: Holding Intake Camshaft In Position

Courtesy of GENERAL MOTORS CORP.

Use an open end wrench on the hex cast into the right intake camshaft, in order to prevent the camshaft from rotating, when loosening the camshaft position actuator oil control valve on the right intake camshaft.

Fig 3: Preventing Exhaust Camshaft Rotation

Courtesy of GENERAL MOTORS CORP.

Use an open end wrench on the hex cast into the right exhaust camshaft, in order to prevent the camshaft from rotating, when loosening the camshaft position actuator oil control valve on the right exhaust camshaft.

Fig 4: Right Camshaft Position Actuators & Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the right camshaft position actuator oil control valves from the right side camshafts.
Slide the right camshaft position actuators off the right side camshafts.

Fig 5: Right Secondary Camshaft Drive Chain

Courtesy of GENERAL MOTORS CORP.

Remove the right secondary camshaft drive chain from the outer camshaft intermediate drive shaft sprocket teeth.
Remove the right secondary camshaft drive chain from the engine.

Fig 6: Right Secondary Camshaft Drive Timing Chain Shoe & Bolt

Courtesy of GENERAL MOTORS CORP.

Fig 7: Right Secondary Camshaft Drive Chain Guide & Bolts

Courtesy of GENERAL MOTORS CORP.