LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - Off Vehicle - 1 Of 3) >> Engine Wiring Harness Assembly Removal >> Left Side Harness Connections

Left Side Harness Connections

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Left Side Fuel Injectors Engine Wiring Harness Connectors
    GM927839Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness from the left side fuel injectors.
  2. Fig 2: Left Camshaft Cover Engine Wiring Harness Connectors
    GM927781Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the engine wiring harness from the left camshaft cover.
  4. Fig 3: Left Coil Assembly Harness Engine Wiring Harness Connector
    GM927828Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the engine wiring harness from the left coil assembly harness.
  6. Fig 4: Left Camshaft Position Sensors Engine Wiring Harness Connectors
    GM927792Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the engine wiring harness from the left camshaft position sensors.
  8. Fig 5: EVAP Purge Solenoid Engine Wiring Harness Connector
    GM927862Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the engine wiring harness from the EVAP purge solenoid.
  10. Fig 6: Throttle Position Sensor Engine Wiring Harness Connector
    GM927869Courtesy of GENERAL MOTORS CORP.
  11. Disconnect the engine wiring harness from the throttle position sensor on the throttle body.
  12. Fig 7: A/C Compressor Engine Wiring Harness Connector
    GM1346039Courtesy of GENERAL MOTORS CORP.
  13. Disconnect the engine wiring harness from the air conditioner compressor.
  14. Fig 8: Oil Pressure Sensor Engine Wiring Harness Connector
    GM1346041Courtesy of GENERAL MOTORS CORP.
  15. Disconnect the engine wiring harness from the oil pressure sensor.