Section 14 (Engine Mechanical - 4.6L (LH2) (5 Of 6))
WARNING: This page is about a different variant/trim than selected.
- Off-Vehicle Repair Instructions - Part 3
- Water Pump Cleaning and Inspection
- Engine Front Cover Assemble
- Camshaft Cover Disassemble
- Camshaft Cover Cleaning and Inspection
- Camshaft Cover Assemble
- Intake Manifold Disassemble
- Intake Manifold Cleaning and Inspection
- Intake Manifold Assemble
- Exhaust Manifold Cleaning and Inspection - Left
- Exhaust Manifold Cleaning and Inspection - Right
- Water Outlet Housing Disassemble
- Water Outlet Housing Cleaning and Inspection
- Water Outlet Housing Assemble
- Thread Repair
- Service Prior to Assembly
- Crankshaft and Bearings Installation
- Piston, Connecting Rod, and Bearing Installation
- Lower Crankcase Installation
- Oil Pump Pipe and Screen Assembly Installation
- Oil Pan Installation
- Cylinder Head Installation - Left
- Valve Lifter Installation - Left
- Valve Rocker Arm Installation - Left
- Camshaft Installation - Left Exhaust
- Camshaft Installation - Left Intake
- Cylinder Head Installation - Right
- Valve Lifter Installation - Right
- Valve Rocker Arm Installation - Right
- Camshaft Installation - Right Exhaust
- Camshaft Installation - Right Intake
- Camshaft Intermediate Drive Shaft Installation
- Primary Camshaft Drive Chain Installation
- Oil Outlet Tube Installation
- Secondary Camshaft Drive Chain Installation - Left
- Secondary Camshaft Drive Chain Installation - Right
- Oil Pump Installation
- Engine Front Cover Installation
- Camshaft Position (CMP) Actuator Housing Installation - Left
- Camshaft Cover Installation - Left
- Ignition Module Installation - Left
- Camshaft Position (CMP) Actuator Housing Installation - Right
- Camshaft Cover Installation - Right
- Ignition Module Installation - Right
- Oil Filter Adapter Installation (Without Oil Cooler)
- Oil Filter Adapter Installation (With Oil Cooler)
- Oil Level Indicator and Tube Installation
- Crankshaft Rear Oil Seal Installation
- Engine Flywheel Installation
- Crankshaft Balancer Installation
- Starter Motor Installation