LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Mechanical - 4.6L (LH2) (5 Of 6)) >> Off-Vehicle Repair Instructions - Part 3 >> Intake Manifold Assemble

Intake Manifold Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Vacuum Boost Fitting
    GM1254538Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the vacuum boost fitting.

    Tighten:  Tighten the vacuum boost fitting to 2 N.m (18 lb in).

    2. Fig 2: View Of Manifold Vacuum Source Cap
    GM1254534Courtesy of GENERAL MOTORS CORP.
  2. Install the manifold vacuum source cap.
    3. Fig 3: View Of Sight Shield Retainer Ball Studs
    GM1254532Courtesy of GENERAL MOTORS CORP.
  3. Install the sight shield retainer ball studs.

    Tighten:  Tighten the sight shield retainer ball studs to 7 N.m (62 lb in).

    4. Fig 4: View Of Intake Manifold-To-Cylinder Head Gaskets
    GM1012862Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not reuse the intake manifold-to-cylinder head sealing gaskets.
  4. Install NEW intake manifold-to-cylinder head gaskets.
scientia non olet · About LEMON Manuals