Section 14 (Engine Controls And Fuel - 2.4L - DTC P0010 To DTC P0114 (LUK))
WARNING: This page is about a different variant/trim than selected.
- Diagnostic Information and Procedures
- DTC P0010, P0013, or P2088, P2089, P2090, P2091: Camshaft Position Actuator Solenoid
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0011 or P0014: Camshaft Position System
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0016 or P0017: Crankshaft Position - Camshaft Position Not Plausible
- DTC P0030, P0031, P0032, P0036, P0037, P0038, P0053, P0054, P0135, or P0141: HO2S Heater Control Circuit
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the MIL/DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P0068 or P1101: Throttle Body Air Flow
- DTC P0089, P00C6, P228C, or P228D: Fuel Pressure Regulator (LEA)
- Diagnostic Instructions
- DTC Descriptors
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0089, P00C6, P228C, or P228D: Fuel Pressure Regulator (LUK)
- Diagnostic Instructions
- DTC Descriptors
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0090, P0091, P0092, P00C8, P00C9, or P00CA: Fuel Pressure Regulator
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0096 or P0111: Intake Air Temperature (IAT) Sensor (LEA)
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTCs
- Conditions for Setting the DTCs
- Action Taken When the DTCs Set
- Conditions for Clearing the DTCs
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0097, P0098, or P0099: Intake Air Temperature (IAT) Sensor 2 (LEA)
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTCs
- Conditions for Setting the DTCs
- Action Taken When the DTC Sets
- Conditions for Clearing the MIL/DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P00F4, P00F5, P00F6: Intake Air Humidity Sensor (LEA)
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTCs
- Conditions for Setting the DTCs
- Action Taken When the DTC Sets
- Conditions for Clearing the MIL/DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0101: Mass Air Flow (MAF) Sensor (LEA)
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit Description
- Conditions for Running the DTCs
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the MIL/DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P0101: Mass Air Flow (MAF) Sensor (LUK)
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit Description
- Conditions for Running the DTCs
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the MIL/DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P0102 or P0103: Mass Air Flow (MAF) Sensor Circuit Frequency (LUK)
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTCs Set
- Conditions for Clearing the MIL/DTCs
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P0102 or P0103: Mass Air Flow (MAF) Sensor Circuit Frequency (LEA)
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTCs Set
- Conditions for Clearing the MIL/DTCs
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P0106: Manifold Absolute Pressure (MAP) Sensor
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0107 or P0108: Manifold Absolute Pressure (MAP) Sensor (LUK)
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0111: Intake Air Temperature (IAT) Sensor (LUK)
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTCs Set
- Conditions for Clearing the DTCs
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0112, P0113, or P0114: Intake Air Temperature (IAT) Sensor (LUK)
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTCs
- Conditions for Setting the DTC
- Action Taken When the DTCs Set
- Conditions for Clearing the DTCs
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0010, P0013, or P2088, P2089, P2090, P2091: Camshaft Position Actuator Solenoid