LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 2.4L - DTC P0010 To DTC P0114 (LUK)) >> Diagnostic Information and Procedures >> DTC P0102 or P0103: Mass Air Flow (MAF) Sensor Circuit Frequency (LEA) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Engine idling, observe the scan tool MAF Sensor parameter. The reading should be between 2.5-5.5g/s.
    • If not between 2.5-5.5g/s 

      Refer to Circuit/System Testing.

    • If between 2.5-5.5g/s 
  2. Verify the scan tool MAF Sensor g/s parameter changes smoothly and gradually as the engine speed is increased and decreased while performing the actions listed below.
    1. Engine idling
    2. Perform the scan tool snapshot function.
    3. Increase the engine speed slowly to 3,000 RPM and then back to idle.
    4. Exit from the scan tool snapshot and review the data.
    5. Observe the MAF Sensor parameter frame by frame with a scan tool.
    • The MAF Sensor parameter does not change smoothly and gradually 

      Refer to Circuit/System Testing.

    • The MAF Sensor parameter changes smoothly and gradually 
  3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  5. All OK
scientia non olet · About LEMON Manuals