Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTC P0010, P0013, P0016, P0017, P0335, P0336, P0340, P0341, P0365, or P0366 is not set.
The ignition voltage is greater than 11V.
The engine is operating.
The desire camshaft position is not changing greater than 4.5 degrees for at least 1s.
Both of the desired and actual camshaft position actuator values cannot be greater than 25 degrees or less than 5 degrees.
DTCs P0011 and P0014 run continuously once the above conditions are met.