Installing the deformation element at the bottom right
NOTE:
Description is for left component only. Procedure on the right side is identical.
Install the bottom deformation element
- Feed in the deformation element (2) .
- Replace screws (1)
.
Parts: Screw
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Deformation element on front subframe | ||
|---|---|---|
| Hexagon bolt with flange M8 Replace screw |
Tightening torque | 19 Nm |
Follow-up work
- Refer to INSTALLING THE FRONT BUMPER COVER .
- Refer to INSTALLING THE FRONT ORNAMENTAL GRILLE/RADOME .
- Refer to INSTALLING THE FRONT RADIATOR GRILL FRAME .
- Refer to INSTALLING THE NUMBER PLATE BASEPLATE FOR THE LICENSE PLATE AT THE FRONT .
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to CLOSING THE ENGINE COMPARTMENT LID .
- Refer to PUTTING THE FRONT RADAR SENSORS INTO OPERATION .