Pull the rubber mount into the rear axle support
- Pull the rubber mounts (1) into the rear axle support up to the stop using special tools 2 411 601, 0 492 397 (33 4 140), 2 208 577, 2 155 744 and 2 208 574
- Remove special tools for inserting rubber mount (1)
.
Follow-up work
- Refer to INSTALLING COMPLETE REAR AXLE SUPPORT .
- Refer to SECURING REAR AXLE .
- Refer to REMOVE THE SPECIAL TOOL FROM THE REAR AXLE .
- Refer to SECURING REAR LEFT AND RIGHT SPRING STRUT SHOCK ABSORBERS ON THE WHEEL CARRIER .
- Refer to INSTALLING THE MOUNTING BLOCKING FOR THE TORSION STRUTS .
- Refer to SECURING REAR LEFT AND RIGHT BRAKE CALIPER .
- Refer to IF INSTALLED: CONNECTING THE CONNECTOR TO THE SERVOMOTOR OF THE REAR AXLE DIFFERENTIAL .
- Refer to IF INSTALLED: SECURING CABLE .
- Refer to IF INSTALLED: CONNECTING THE CABLE (ADDITIONAL WORK ON ACTIVE STABILIZER .
- Refer to CONNECTING THE CONNECTORS ON LEFT AND RIGHT .
- Refer to SECURING CABLES ON RIGHT AND LEFT .
- Refer to CONNECTING THE CONNECTOR TO THE REAR RIDE HEIGHT SENSOR .
- Refer to SECURING THE PROPELLER SHAFT ON THE REAR AXLE DIFFERENTIAL .
- Refer to INSTALLING THE HEAT SHIELD AT THE REAR .
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to INSTALLING THE REAR DIFFUSER .
- Refer to IF INSTALLED: INSTALLING THE REAR AXLE COVER .
- Refer to INSTALLING THE TORSION STRUT ON THE REAR LEFT AND RIGHT .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING THE UNDERBODY PLANKING OF THE TRANSMISSION ON THE SIDE .
- Refer to INSTALLING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .
- Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .
- Refer to PLACING THE BRAKE PADS ON THE BRAKE DISK/PUTTING THEM INTO OPERATION .