Checking the end stops of the electrical wastegate valve controller
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Carry out the following steps only if the check for the end stops of the electrical wastegate valve controller is predefined by the vehicle diagnosis.
- Connect diagnostic system:
- Service functions
- Power train
- Engine electrical system
- Adjustment programs
- Checking the end stops of the wastegate linkage
Follow-up work
- Refer to INSTALLING THE HEAT SHIELD ON THE EXHAUST TURBOCHARGER, TOP .
- Refer to INSTALLING THE OXYGEN SENSOR MONITOR .
- Refer to INSTALLING LAMBDA OXYGEN SENSOR .
- Refer to INSTALLING BATTERY CARRIER .
- Refer to INSTALLING E-BOX .
- Refer to INSTALLING THE SYSTEM BATTERY .
- Refer to CONNECTING BATTERY GROUND LEAD .
- Refer to PREPARING FOR THE INSTALLATION OF THE CLEAN AIR PIPE .
- Refer to INSTALLING CLEAN AIR PIPE .
- Refer to INSTALLING THE REAR BULKHEAD .
- Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .
- Refer to INSTALLING THE FRONT RIGHT WHEEL .