Installing clean air pipe
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Feed in and position the clean air pipe (2).
- Secure clamps (4).
- Connect and lock the connector (3).
- Make sure the connector (3) engages audibly.
- Feed in clean air pipe (2) and install.
- Make sure that the clamp (1) engages audibly.
- Tighten down screw (3).
TIGHTENING TORQUE SPECIFICATIONS
| Clean air pipe to cylinder head cover | ||
|---|---|---|
| TS6x20 | tightening torque | 8 Nm |
- Connect the engine ventilation lines (1) to the clean air pipe and lock in place.
- Make sure that the engine ventilation lines (1) engage audibly into the clean air pipe.
- Connect the engine ventilation line (2) to the cylinder head cover and lock in place.
- Make sure that the engine ventilation line (2) engages audibly on the cylinder head cover.
Follow-up work
- Refer to INSTALLING THE REAR BULKHEAD .
- Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .
- Refer to FOR REPLACEMENT: RESET ADAPTATION VALUES .