Install E-box
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Slide E-box (1) in the direction of the arrow into the guide (2) and install it.
- Make sure that the E-box (1) is positioned correctly at the FIREWALL (2).
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
E-box to battery tray M8X16 tightening torque 15 Nm - Slide holder (1) in direction of arrow into the E-box (2) and install it.
- Make sure the holder (1) engages audibly.
- Guide in the wiring harness section (2) of the engine in the direction of the arrow and install.
The locks (1) must engage audibly.
- Insert and install the wiring harness section (2) for the Valvetronic servomotor in the direction of the arrow.
The locks (1) must engage audibly.
- Feed in the wiring harness section (3) for injectors and ignition coils in the arrow direction and install.
The lock (2) must engage audibly.
- Insert and install the positive battery cable (1).
- Connect connectors (1) and lock.
The connectors (1) must engage audibly.
- Connect and lock the connector (1) in the arrow direction.
The connectors (1) must engage audibly.
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
- Insert and install the connector (1) to the E-box (2) in the direction of the arrow.
- Feed the cover (2) into the guides (3) in the arrow direction and install.
The cover (2) must audibly engage into the guides (3).
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
Cover panel to E-box RF5x26.5 Tightening torque 25 Nm - Insert and install the positive battery cable (2) on the holder (3).
- Insert and install the battery positive terminal (1).
- Tighten the battery positive terminal (1).TIGHTENING TORQUE SPECIFICATIONS
Positive battery terminal to battery Nut M6 tightening torque 5 Nm - Insert and install the tension strut (2).
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Tension strut on shock tower/battery tray | ||
|---|---|---|
| M8 | tightening torque | 19 Nm |
Follow-up work
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .
- Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to CONNECTING THE BATTERY EARTH LEAD .