Installing the servomotor for the eccentric shaft

• Replace seal (1). 

  Parts:  Gasket

  Courtesy of BMW OF NORTH AMERICA, INC.

• Press the gasket (1)  in to the stop on the housing.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Grease the gearing (1)  of the servomotor for the eccentric shaft (2)  in the marked area. 

Parts:  lubric. grease

Consumable 

Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the servomotor (1)  to the gearing.
• Turn the drive shaft of the servomotor (1)  to the right using tool (2)  until the servomotor (1)  is flush with the cylinder head.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1). 
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Electrical servomotor to cylinder head
  M6	10 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connector (1). 

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE INTAKE PLENUM .
• Refer to INSTALLING CHARGE AIR LINE .
• Refer to INSTALLING CLEAN AIR PIPE .
• Refer to INSTALLING INTAKE SILENCER HOUSING .
• Refer to INSTALLING CORROSION PROTECTION COVER .
• Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART .
• Refer to REMOVING/INSTALLING TRAILING LINK AT TENSION STRUT TOWER .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
• Refer to INSTALLING CONTROL UNIT HOLDER .
• Refer to CONNECTING THE COOLANT LINE TO THE LOW-TEMPERATURE COOLING SYSTEM .
• Refer to INSTALLING BOTH COOLANT EXPANSION TANKS .
• Refer to FILLING THE LOW-TEMPERATURE COOLANT CIRCUIT WITH THE VACUUM FILLER DEVICE .
• Refer to INSTALLING BATTERY HOUSING (ENGINE COMPARTMENT) .
• Refer to INSTALLING AUXILIARY BATTERY (ENGINE COMPARTMENT) .
• Refer to CONNECTING NEGATIVE BATTERY CABLE (ENGINE COMPARTMENT) .
• Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
• Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
• Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to VERSION WITH ECCENTRIC SHAFT SERVOMOTOR: TEACHING IN THE END STOPS WITH THE DIAGNOSTIC SYSTEM .
• Refer to BLEEDING THE LOW-TEMPERATURE COOLING SYSTEM .
• Refer to CHECKING LOW-TEMPERATURE COOLING SYSTEM FOR WATERTIGHTNESS .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE DESIGN COVER .
• Refer to INSTALLING THE UNDERBODY PANELLING ON THE SIDES .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .