Installing sound insulation at the center of the bulkhead upper part

• Check the seal on the bottom of the sound insulation (2)  for damage, replace if necessary.
• Position the sound insulation (2). 
• Tighten the screws (1). 
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Sound insulation on bulkhead upper part
  Screw	8.0 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the sealing (2)  in the direction of arrow.
• Fasten expanding rivet (1). 
• Secure positive battery cable at the sealing (2). 

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING TENSION STRUT ON SPRING STRUT TOWER .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .