Section 190 (Drive Shaft Seal (Right), Turbocharger - Removal & Installation)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2007 Volvo V70, 2006 Volvo V70, 2005 Volvo V70, 2004 Volvo V70, and 2003 Volvo V70. However, it is still accessible from the selected car via links, so may be relevant.
- Engine
- Drive Shaft Seal, Right, Replacing
- Replacing The Turbocharger (TC)
- Replacing The Wiring Harness / Oil Temperature Sensor
- Notes
- Removal
- Preparations
- Remove The Gearbox Cable From The Lever On The Gearbox
- Disassembling The Large Connector
- Removing The Lever On The Gear Shift Linkage Rod
- Installing The Lifting Beam And Lifting Hook
- Lifting The Car
- Removing The Screw For The Right Drive Shaft
- Removing The Screws For The Cable Conduit And Ground Lead Bracket On The Sub-Frame
- Removing The Ball Joint Nuts (Both Sides)
- Removing The Bracket For The Cable For The Heated Oxygen Sensor (HO2S)
- Removing The Collision Protection System Over The Steering Gear
- Removing The Steering Gear From The Sub-Frame
- Removing The Screws From The Sub-Frame Support Brackets (Both Sides)
- Lowering The Sub-Frame
- Draining The Gearbox Fluid
- Removing The Control System Cover
- Removing The Cable Harness
- Installation
- Connecting the cable harness
- Sealing the cover
- Installing the control system cover
- Installing the sub-frame
- Installing components in the steering gear and sub-frame
- Installing the nuts securing the ball joint to the control arm and the anti-roll bar to the link rods
- Installing the collision protection system over the steering gear
- Installing the bracket for the heated oxygen sensor (HO2S)
- Installing the screw for the drive shaft
- Installing components on the sub-frame
- Installing the splash guard under engine
- Removing Lifting Beams And The Lifting Hook
- Assembling The Connectors
- Safety Information Cooling System