Removing The Control System Cover

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2007 Volvo V70, 2006 Volvo V70, 2005 Volvo V70, 2004 Volvo V70, and 2003 Volvo V70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Removal Of Sealing Compound From Threads Using A Tap

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the Torx TX40 screws for the control system cover.

Clean the sealing compound from the threads. Use tap M8 x 1. 25.

Remove the cover. Use gasket wedge 9995477 . Carefully tap it in between the cover and gearbox so as not to bend the seal flange on the cover.

Clean the gasket residue from the cover and the gearbox.

NOTE:

Ensure that no debris enters the gearbox. Wash the cover thoroughly.