Section 178 (Transmission Control Module, Clutch Driven Plate - Removal & Installation (Coupe))
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission
- Pressure plate / clutch driven plate, replacing
- Notes
- Removal
- Blocking the flywheel
- Aligning the counterhold for automatic clutch adjustment
- Installing the compression tool
- Relieving the load from the clutch diaphragm spring
- Checking the clutch
- Checking the pressure plate for out-of-true
- Checking the clutch driven plate
- Checking that there are no cracks or large scratches on the flywheel
- Installation
- Transmission control module (TCM), replacing
- Transmission, installing
- Notes
- Installation
- Notes
- Installing the transmission
- Adjusting the height and angle using the mobile jack and the transmission fixture
- Installing and tightening the screws for the transmission
- Installing the torque converter screws
- Lifting the engine and transmission to the horizontal position
- Installing the rear engine mounting
- Installing the bevel gear
- Installing the lower charge air pipe
- Installing the lower oil pipe on the transmission
- Installing the left drive shaft on the transmission and the wheel spindle
- Installing the subframe on the bodywork
- Installing the right-hand drive shaft on the transmission, wheel spindle and control arm
- Installing components on the engine and subframe
- Installing the collision protection system over the steering gear
- Installing the servo pipe in the holders
- Installing the propeller shaft
- Installing the center bearing and member for the propeller shaft
- Installing the front mounting for the exhaust pipe
- Installing the cross members on the bodywork
- Installing and tightening front end components (both sides)
- Installing components for the fender liner
- Installing the cable duct
- Installing the front splash guard
- Removing the lifting beams
- Removing lifting beams and the lifting hooks from the engine
- Installing the exhaust gas recirculation (EGR) cooler
- Installing the vacuum pump
- Installing the gear selector cable and oil pipe
- Installing service clips
- Installing engine compartment components
- Checking the boot for the steering shaft/firewall
- Installing the battery lead
- Pressure plate / clutch driven plate, replacing