Installing the servo pipe in the holders
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Press the power steering pipe and the evaporator pipe into the holders on the subframe. If there is a parking heater, also press the fuel line and the evaporator cable into place.
Install and tighten the clamps for the servo line at the rear of the subframe.