Installing engine compartment components: Notes
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Install:
- the inner of the two hose couplings for the passenger compartment heater connecting sleeve in the firewall
- the charge air pipe for the turbocharger (TC)
- the cable harness to the charge air pipe. Use a tie strap
- the hose between the intake manifold and charge air cooler (CAC)
- the clamp for the cable harness on the engine.
Tighten the 1 x M10 nut for the rear engine pad.
Install:
- the air cleaner (ACL) housing assembly with the intake manifold and connections
- hook the control valve onto the air cleaner (ACL) housing
- the upper engine stabilizer brace between the wheel arches. Use 4 x M10 screws. Tighten
- 1 x M12 screw for the engine stabilizer brace/engine mounting. Tighten
- the tie strap for the power steering return line in the mounting lug for the engine stabilizer brace on the right-hand side
- the cover over the engine.
Fill with coolant. Carefully check while reaching operating temperature or test driving that the level remains the same and that there is no leakage.