Remove/install automatic transmission fluid cooler - AR27.55-P-1000EWM
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
TRANSMISSION 725.0 in MODEL 212 with ENGINE 642
| Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure. Risk of poisoning from swallowing hydraulic fluid. | Depressurize hydraulic system completely before starting any work on it. Wear protective clothing and safety glasses. | AS00.00-Z-0013-01A | |
| Remove/install | |||
| 1 | Remove engine cover | ||
| 2.1 | Remove radiator grille | TRANSMISSION 725.0 in MODEL 212 with ENGINE 642 as of model year 2014 without CODE 772 (AMG styling package - front spoiler, side skirts and rear apron) without CODE 954 (Avantgarde) |
|
| AR88.40-P-4001EWM | |||
| 2.2 | Remove front bumper | TRANSMISSION 725.0 in MODEL 212 with ENGINE 642 as of model year 2014 with CODE 772 (AMG styling package - front spoiler, side skirts and rear apron) with CODE 954 (Avantgarde) |
|
| AR88.20-P-2000EWM | |||
| 3 | Remove center front reinforcement (1) | AR62.30-P-1570EW | |
| 4 | Unclip air duct segment (2) and place to one side | ||
| 5 | Remove electric controller unit for DISTRONIC (A89) together with bracket (4) | TRANSMISSION 725.0 in MODEL 212 with ENGINE 642 with CODE 233 (DISTRONIC PLUS) |
|
| 6 | Detach oil lines (5) from oil cooler (6) | AR27.10-P-0501-03CW | |
| Figure | |||
| 7 | Remove screw/bolts (7) | ||
| 8 | Unclip and remove oil cooler (6) | ||
| 9 | Install in the reverse order | ||
| Check | |||
| 10 | Check oil level in transmission and correct if necessary | TRANSMISSION 725.0 in MODEL 212 with ENGINE 642 with CODE 805 (Model year 2015) |
AR27.00-P-0270EWN |
| TRANSMISSION 725.0 in MODEL 212 with ENGINE 642 without CODE 805 (Model year 2015) |
AR27.00-P-0270EWM | ||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 11 | Carry out engine test run, while doing so check transmission for proper operation and check oil cooler (6) for leaktightness |