Subsequent Work

Information 

Only for vehicles with tire pressure monitoring

1. Install rear wheel housing liner. → Installing Rear Wheel Housing Liner - section on "Installing"
2. Install rear underbody cover. → Installing Cover For Rear Underbody - section on "Installing"
3. Install reservoir. → Installing Coolant Reservoir - section on "Installing"
4. Install air cleaner housing. → Installing Air Cleaner Housing - section on "Installing"
5. Install rear spoiler. → Installing Rear Spoiler - section on "Installing"
6. Install rear light at left and right. → Installing Tail Light - section on "Installing"
7. Install additional brake light. → Installing Auxiliary Brake Light - section on "Installing"

   Information 

   Only in the cabrio.

8. Install roll-over bar. → Installing Roll-Over Bar Module - section on "Installing"

   Information 

   Only in the cabrio.

9. Install frame for roll-over protection system. → Installing Frame For Roll-Over Protection System - section on "Installing"
10. Install relay carrier. → Installing Relay Carrier 1  - section on "Installing" 
11. Install trim panel for seat well. → Installing Trim Panel For Seat Well - section on "Installing"
12. Install trim panel for rear wall → Installing Trim Panel For Rear Wall - section on "Installing"

    Information 

    Only in the coupe.

13. Install C-pillar trim panel. → Installing C-Pillar Trim - section on "Installing"
14. Install rear side trim panel at left and right. → Installing Rear Side Trim Panel - section on "Installing"
15. Install left and right scuff plate. → Installing Inner Door Sill Trim - section on "Installing"
16. Install front seat at left and right. → Installing Front Seat - section on "Installing"
17. Carry out work instructions after disconnecting the battery. → Disconnecting And Connecting The Battery