Section 12 (Engine Mechanical - 2.0L - Repair Instructions - Off Vehicle (1 Of 2))
WARNING: This page is about a different variant/trim than selected.
- Engine Mounting to Stand
- Engine Oil Cooler Removal
- Draining Fluids and Oil Filter Removal
- Crankshaft Balancer Removal
- Engine Flywheel Removal (Automatic Transmission)
- Engine Flywheel Removal (Manual Transmission)
- Oil Level Indicator and Tube Removal
- Starter Removal
- Intake Manifold Removal
- Fuel Rail and Injectors Removal
- Turbocharger Removal
- Exhaust Manifold Removal
- Camshaft Cover Removal
- Engine Front Cover and Oil Pump Removal
- Timing Chain and Tensioner Removal
- Intake and Exhaust Camshaft, Bearing Cap, and Lash Adjuster Removal
- Water Pump and Balance Shaft Chain and Tensioner Removal
- Balance Shaft Removal
- Water Pump Removal
- Cylinder Head Removal
- Oil Pan Removal
- Piston, Connecting Rod, and Bearing Removal
- Lower Crankcase Removal
- Crankshaft and Bearing Removal
- Engine Block Disassemble
- Engine Block Cleaning and Inspection
- Cylinder Honing
- Cylinder Sleeve Removal
- Cylinder Sleeve Installation
- Crankshaft Balancer Cleaning and Inspection
- Engine Flywheel Cleaning and Inspection
- Crankshaft and Bearing Cleaning and Inspection
- Piston and Connecting Rod Disassemble
- Piston, Connecting Rod, and Bearing Cleaning and Inspection
- Piston and Connecting Rod Assemble
- Camshaft Cleaning and Inspection
- Camshaft Timing Chain and Sprocket Cleaning and Inspection
- Balance Shaft Cleaning and Inspection
- Water Pump and Balance Shaft Chain and Sprocket Cleaning and Inspection
- Cylinder Head Disassemble
- Cylinder Head Cleaning and Inspection
- Valve and Seat Grinding
- Valve Measurement and Reconditioning Overview
- Valve Seat Width Measurement Procedure
- Valve Seat Roundness Measurement Procedure
- Valve Head O.D. and Chamfer Measurement Procedure
- Valve-to-Seat Concentricity Measurement Procedure
- Valve and Seat Reconditioning Procedure
- Valve Stem Height Measurement Procedure
- Cylinder Head Assemble
- Oil Pump Disassemble
- Oil Pump Assemble
- Turbocharger Cleaning and Inspection
- Fuel Rail and Injectors Cleaning and Inspection
- Intake Manifold Cleaning and Inspection
- Exhaust Manifold Cleaning and Inspection
- Oil Pan Cleaning and Inspection