LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical - 2.0L - Repair Instructions - Off Vehicle (1 Of 2)) >> Intake and Exhaust Camshaft, Bearing Cap, and Lash Adjuster Removal >> Exhaust Camshaft Removal

Exhaust Camshaft Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Exhaust Camshaft & Caps
    GM1825040Courtesy of GENERAL MOTORS CORP.
    NOTE: Remove each bolt on each cap one turn at a time until there is no spring tension pushing on the camshaft.
  1. Mark camshaft caps to ensure they are installed in the same position.
  2. Remove the exhaust camshaft cap bolts.
  3. Remove the camshaft caps ensuring they are marked and refitted in same position on assembly.
  4. Remove the exhaust camshaft.
    5. Fig 2: View Of Exhaust Camshaft Roller Finger Followers
    GM1825041Courtesy of GENERAL MOTORS CORP.
    NOTE: Keep all of the roller finger followers and hydraulic lash adjusters in order so that they can be reinstalled in their respective locations.
  5. Remove the exhaust camshaft roller finger followers.
    6. Fig 3: View Of Hydraulic Lash Adjusters
    GM1825043Courtesy of GENERAL MOTORS CORP.
  6. Remove the hydraulic lash adjusters.
scientia non olet · About LEMON Manuals