Rear Speaker Inspection

Disconnect the negative battery cable.
Remove the following parts:
1. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
2. Sub-trunk (See SUB-TRUNK REMOVAL/INSTALLATION .)
3. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
4. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
5. Third-row seat belt lower anchor installation bolt (See THIRD-ROW SEAT BELT REMOVAL/INSTALLATION .)
6. Cargo compartment light (See CARGO COMPARTMENT LIGHT REMOVAL/INSTALLATION .)
7. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
8. Rear header trim (See REAR HEADER TRIM REMOVAL/INSTALLATION .)
9. Second-row seat belt upper anchor installation bolt (See SECOND-ROW SEAT BELT REMOVAL/INSTALLATION .)
10. C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
11. Rear speaker (See REAR SPEAKER REMOVAL/INSTALLATION .)
Verify the resistance between the rear speaker terminals.

Fig 1: Identifying Rear Speaker Terminals
- If not within the specification, replace the rear speaker.
  
  Fig 2: Rear Speaker Terminals Resistance Chart