LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Heating / Air Conditioning System) >> Front Evaporator Temperature Sensor >> Installation

Front Evaporator Temperature Sensor: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL NO. 1 COOLER THERMISTOR 
    1. Install the No 1 cooler thermistor
      NO. 1 COOLER THERMISTOR DESCRIPTION

      Part Length
      A 48 to 52 mm 1 89 to 2 05 in
      B 49 mm 1 93 in
      Fig 1: Identifying No. 1 Cooler Thermistor
      G05755358Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
      • After inserting the thermistor, do not apply excessive force to the wire.
  2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY  (See REASSEMBLY  )
  3. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY  (See REASSEMBLY  )
  4. INSTALL AIR OUTLET CONTROL SERVO MOTOR  (See REASSEMBLY  )
  5. INSTALL AIR MIX CONTROL SERVO MOTOR  (See REASSEMBLY  )
  6. INSTALL AIR CONDITIONING HARNESS ASSEMBLY  (See REASSEMBLY  )
  7. INSTALL COOLER EXPANSION VALVE  (See REASSEMBLY  )
  8. INSTALL AIR MIX CONTROL SERVO MOTOR  (See REASSEMBLY  )
  9. INSTALL COOL AIR BY-PASS CONTROL SERVO MOTOR  (See REASSEMBLY  )
  10. INSTALL BLOWER ASSEMBLY  (See REASSEMBLY  )
  11. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY  (See INSTALLATION  )
  12. INSTALL NO. 2 AIR DUCT  (See INSTALLATION  )
  13. INSTALL AIR CONDITIONER UNIT ASSEMBLY  (See INSTALLATION  )
  14. INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY  (See INSTALLATION  )
  15. INSTALL ID CODE BOX (IMMOBILIZER CODE ECU)  (See INSTALLATION )
  16. INSTALL DEFROSTER NOZZLE LOWER ASSEMBLY  (See INSTALLATION  )
  17. INSTALL SKID CONTROL ECU  (See INSTALLATION )
  18. INSTALL STEERING COLUMN ASSEMBLY  (See INSTALLATION )
  19. INSTALL BRAKE PEDAL RETURN SPRING  (See INSTALLATION )
  20. INSTALL NO. 1 AIR DUCT  (See INSTALLATION )
  21. CONNECT STEERING SLIDING YOKE SUB-ASSEMBLY  (See INSTALLATION )
  22. INSTALL INSTRUMENT PANEL STAY  (See INSTALLATION )
  23. INSTALL INSTRUMENT PANEL CLIP  (See INSTALLATION )
  24. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY  (See INSTALLATION )
  25. CONNECT INSTRUMENT PANEL WIRE ASSEMBLY  (See INSTALLATION )
  26. INSTALL NO. 1 CONSOLE BOX DUCT  (See INSTALLATION )
  27. INSTALL NO. 2 CONSOLE BOX DUCT  (See INSTALLATION )
  28. INSTALL FRONT STEREO COMPONENT SPEAKER ASSEMBLY (w/ Front Center Speaker)  (See INSTALLATION )
  29. INSTALL NO. 3 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY  (See INSTALLATION )
  30. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY  (See INSTALLATION )
  31. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY  (See INSTALLATION )
  32. INSTALL FRONT PILLAR GARNISH LH  (See INSTALLATION )
  33. INSTALL FRONT PILLAR GARNISH RH 

    HINT.

    Use the same procedure for the RH side and LH side (See INSTALLATION )

  34. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY  (See INSTALLATION )
  35. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY  (See INSTALLATION )
  36. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
  37. INSTALL SIDE INSTRUMENT PANEL RH  (See INSTALLATION )
  38. INSTALL FRONT DOOR OPENING TRIM COVER RH 

    HINT

    Use the same procedure for the RH side and LH side (See INSTALLATION ).

  39. INSTALL FRONT DOOR SCUFF PLATE RH 

    HINT

    Use the same procedure for the RH side and LH side (See INSTALLATION ).

  40. INSTALL COMBINATION METER ASSEMBLY  (See INSTALLATION )
  41. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  (See INSTALLATION )
  42. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY  (See INSTALLATION )
  43. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  (See INSTALLATION )
  44. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
  45. INSTALL SIDE INSTRUMENT PANEL LH  (See INSTALLATION )
  46. INSTALL FRONT DOOR OPENING TRIM COVER LH  (See INSTALLATION )
  47. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
  48. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY  (See INSTALLATION )
  49. INSTALL STEERING COLUMN COVER  (See INSTALLATION )
  50. ADJUST SPIRAL CABLE SUB-ASSEMBLY  (See INSTALLATION )
  51. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  52. INSTALL STEERING PAD  (See INSTALLATION )
  53. INSTALL LOWER NO. 3 STEERING WHEEL COVER  (See INSTALLATION )
  54. INSTALL LOWER NO. 2 STEERING WHEEL COVER  (See INSTALLATION )
  55. INSTALL INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (w/o Navigation System)  (See INSTALLATION )
  56. INSTALL MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY (w/ Navigation System)  (See INSTALLATION )
  57. INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL  (See INSTALLATION )
  58. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY  (See INSTALLATION )
  59. INSTALL CONSOLE BOX  (See INSTALLATION )
  60. INSTALL CONSOLE BOX REGISTER ASSEMBLY  (See INSTALLATION )
  61. INSTALL REAR ASH RECEPTACLE ASSEMBLY  (See INSTALLATION )
  62. INSTALL FRONT ASH RECEPTACLE ASSEMBLY  (See INSTALLATION )
  63. INSTALL CONSOLE PANEL SUB-ASSEMBLY  (See INSTALLATION )
  64. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH  (See INSTALLATION )
  65. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH  (See INSTALLATION )
  66. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY  (See INSTALLATION )
  67. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See INSTALLATION )
  68. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See INSTALLATION )
  69. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See INSTALLATION )
  70. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See INSTALLATION )
  71. INSTALL FRONT WIPER ARM HEAD CAP  (See INSTALLATION )
  72. INSTALL ROOF DRIP SIDE FINISH MOLDING LH  (See INSTALLATION )
  73. INSTALL ROOF DRIP SIDE FINISH MOLDING RH 

    HINT.

    Use the same procedure for the RH side and LH side (See INSTALLATION ).

  74. INSTALL FRONT UPPER FENDER PROTECTOR LH  (See INSTALLATION )
  75. INSTALL FRONT UPPER FENDER PROTECTOR RH 

    HINT.

    Use the same procedure for the RH side and LH side (See INSTALLATION ).

  76. INSTALL HEATER WATER INLET HOSE  (See INSTALLATION  )
  77. INSTALL HEATER WATER OUTLET HOSE  (See INSTALLATION  )
  78. INSTALL COOLER REFRIGERANT LIQUID PIPE A  (See INSTALLATION  )
  79. INSTALL SUCTION PIPE SUB-ASSEMBLY  (See INSTALLATION  )
  80. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  81. CHARGE REFRIGERANT  (See REPLACEMENT  )
  82. WARM UP ENGINE  (See REPLACEMENT  )
  83. INSPECT FOR REFRIGERANT LEAK  (See REPLACEMENT  )
  84. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  85. INSTALL ENGINE ROOM SIDE COVER RH  (See INSTALLATION )
  86. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
scientia non olet · About LEMON Manuals