Blower Unit: Reassembly

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL COOLING UNIT WITH FAN MOTOR SUB-ASSEMBLY
1. Install the fan motor with the 3 screws.
  
  Fig 1: Locating Fan Motor Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CLEAN AIR FILTER
1. Attach the 2 claws to install the air filter
  
  Fig 2: Identifying Air Filter Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INLET CONTROL SERVO MOTOR
1. Install the inlet control servo motor with the 2 screws.
  
  Fig 3: Locating Damper Servo Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Attach the claw and install the lever
  
  Fig 4: Identifying Claw On Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002