Section 160 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (3 Of 5))
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- On-Vehicle Repair Instructions (2 Of 2)
- Off-Vehicle Repair Instructions (1 Of 3)
- Draining Fluids and Oil Filter Removal
- Crankshaft Balancer Removal
- Automatic Transmission Flex Plate Removal
- Oil Level Indicator and Tube Removal
- Exhaust Manifold Removal - Left Side
- Exhaust Manifold Removal - Right Side
- Water Pump Removal (RPO LY2/LC9/LY5/LMG)
- Water Pump Removal (RPO LY6/L76/L92)
- Throttle Body Removal
- Fuel Rail and Injectors Removal
- Intake Manifold Removal (RPO LY2/LY6)
- Intake Manifold Removal (RPO LC9/LY5/LMG/L76)
- Intake Manifold Removal (RPO L92)
- Engine Coolant Air Bleed Pipe and Hole Cover Removal (RPO LY2/LY6)
- Engine Coolant Air Bleed Pipe and Hole Cover Removal (RPO LC9/LY5/LMG/L76)
- Engine Coolant Air Bleed Pipe and Hole Cover Removal (RPO L92)
- Engine Valley Cover Removal
- Valve Lifter Oil Manifold Removal
- Valve Lifter Oil Filter Removal
- Valve Rocker Arm Cover Removal - Left Side
- Valve Rocker Arm Cover Removal - Right Side
- Valve Rocker Arm and Push Rod Removal (RPO LY2/LC9/LY5/LMG/LY6/L76)
- Valve Rocker Arm and Push Rod Removal (RPO L92)
- Cylinder Head Removal - Left Side
- Cylinder Head Removal - Right Side
- Valve Lifter Removal (RPO LY2/LY6)
- Valve Lifter Removal (RPO LC9/LY5/LMG/L76)
- Valve Lifter Removal (RPO L92)
- Oil Filter Removal
- Oil Pan Removal
- Engine Front Cover Removal (RPO LY2/LC9/LY5/LMG)
- Engine Front Cover Removal (RPO LY6/L76/L92)
- Crankshaft Rear Oil Seal Housing Removal
- Oil Pump, Screen and Crankshaft Oil Deflector Removal (RPO LY2/LC9/LY5/LMG)
- Oil Pump, Screen and Crankshaft Oil Deflector Removal (RPO LY6/L76/L92)
- Timing Chain and Sprockets Removal
- Camshaft Position Actuator and Solenoid Valve Removal
- Camshaft Removal
- Piston, Connecting Rod, and Bearing Removal
- Crankshaft and Bearings Removal
- Engine Block Plug Removal
- Engine Block Cleaning and Inspection
- Cylinder Boring and Honing