LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (3 Of 5)) >> Off-Vehicle Repair Instructions (1 Of 3) >> Oil Level Indicator and Tube Removal

Oil Level Indicator and Tube Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Indicator, Tube Bolt, Indicator Tube & O-Ring Seal
    GM1658141Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil level indicator (418) from the tube.
  2. Remove the oil level indicator tube bolt (419).
  3. Remove the oil level indicator tube (420) from the engine block.
    4. IMPORTANT: Inspect the O-ring for cuts or damage. The O-ring seal may be used again if it is not cut or damaged.
  4. Remove the O-ring (421) from the tube, as required.
scientia non olet · About LEMON Manuals