LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (3 Of 5)) >> On-Vehicle Repair Instructions (2 Of 2) >> Automatic Transmission Flex Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Flywheel & Bolts
    GM832979Courtesy of GENERAL MOTORS CORP.
  1. Remove the automatic transmission. Refer to Transmission Replacement for the 4L60-E or Transmission Replacement for the 4L80-E.
    2. IMPORTANT: Note the position and direction of the engine flywheel before removal.
  2. Remove the flywheel bolts.
  3. Remove the flywheel.
    4. Fig 2: View Of Bolts & Spacer
    GM642281Courtesy of GENERAL MOTORS CORP.
  4. Install two M11x1.5 mm bolts (1) to the threaded holes of the spacer, if applicable.
  5. Rotate the bolts clockwise to remove the spacer.
    6. Fig 3: View Of Spacer & Crankshaft Rear
    GM642276Courtesy of GENERAL MOTORS CORP.
  6. Remove the spacer from the rear of the crankshaft, if applicable.
scientia non olet · About LEMON Manuals