LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (3 Of 5)) >> Off-Vehicle Repair Instructions (1 Of 3) >> Valve Rocker Arm and Push Rod Removal (RPO L92)

Valve Rocker Arm and Push Rod Removal (RPO L92)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Offset Intake Rocker Arm & Intake Rocker Arm
    GM1814082Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Place the valve rocker arms, valve pushrods, and pivot support, in a rack so they can be installed in the same location from which they were removed.
  1. Remove the valve rocker arm bolts.
  2. Remove the valve rocker arms.

    The intake rocker arms (1) have an offset design.

    3. Fig 2: View Of Valve Rocker Arm Pivot Support
    GM260141Courtesy of GENERAL MOTORS CORP.
  3. Remove the valve rocker arm pivot support.
    4. Fig 3: View Of Pushrods
    GM260142Courtesy of GENERAL MOTORS CORP.
  4. Remove the pushrods.
scientia non olet · About LEMON Manuals