LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (3 Of 5)) >> Off-Vehicle Repair Instructions (1 Of 3) >> Camshaft Removal

Camshaft Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Camshaft Retainer & Bolts
    GM1552492Courtesy of GENERAL MOTORS CORP.
  1. Remove the camshaft retainer bolts (204) and retainer (203).
    2. Fig 2: View Of Camshaft
    GM1704626Courtesy of GENERAL MOTORS CORP.
    NOTE: All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft bearings.
  2. Remove the camshaft.
    1. Install the camshaft sprocket bolt into the camshaft front bolt hole.
    2. Using the bolt as a handle, carefully rotate and pull the camshaft out of the engine block.
    3. Remove the bolt from the front of the camshaft.
scientia non olet · About LEMON Manuals