LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (3 Of 5)) >> Off-Vehicle Repair Instructions (1 Of 3) >> Automatic Transmission Flex Plate Removal

Automatic Transmission Flex Plate Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Flex Plate & Bolts
    GM1658140Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The flex plate does not use a locating pin for alignment and will not initially seat against the crankshaft flange, but will be pulled onto the crankshaft by the engine flex plate bolts. This procedure requires a 3 stage tightening process.
  1. Remove the engine flex plate bolts.
  2. Remove the flex plate.
scientia non olet · About LEMON Manuals