Electronic Suspension - Real-Time Damping

• Description & Operation
  • Notes
  • RTD IPC Message Descriptions
    • Shocks Inoperative
    • Service Ride Control
    • Maximum Speed
  • Component Operation
    • Adjustable Shock Absorbers
    • Damper Solenoid Valves
    • Position Sensors
    • Real Time Damping (RTD) Control Module
    • Ride Control Switch
  • Self-Diagnostics
• Diagnosis & Testing
  • On-Board Diagnostic System
    • Notes
    • Entering On-Board Diagnostics
    • Automatic Mode
    • Manual Mode
  • RTD Diagnostic System Check (
  • Clearing Diagnostic Trouble Codes
    • Notes
    • Tech 1 Scan Tool Method
    • IPC Diagnostic Method
    • Ignition Cycle Default Method
  • Notes On INTERMITTENTS
• Connector Identification
• Diagnostic Tests
  • Notes
  • DTC B2795: Suspension Control Select Switch Malfunction
  • DTC B3577: Suspension Control Select Switch Contact Malfunction
  • DTC C0550: Ecu Malfunction
  • DTC C0563: Calibration ROM Checksum Error
  • DTC C0577, DTC C0578, DTC C0579, DTC C0582, DTC C0583, DTC C0584, DTC C0587, DTC C0588, DTC C0589, DTC C0592, DTC C0593 Or DTC C0594: Damper Solenoid Circuit Low, High Or Open
  • DTC C0615, DTC C0620, DTC C0625 or DTC C0630: POSITION SENSOR MALFUNCTION
  • DTC C0665: Chassis Pitch Signal Circuit
  • DTC C0690: Damper Control Relay Circuit Malfunction
  • DTC C0691: Damper Control Relay Circuit Range (Open Or Short To Ground)
  • DTC C0693: Damper Control Relay Circuit High (Short To Battery Voltage)
  • DTC C0695: Position Sensor OVERCURRENT (8-Volt Supply)
  • DTC C0710: Steering Position Signal Malfunction
  • DTC P1652: Power Control Module Grounding Circuit Malfunction
• Removal & Installation
  • Notes
  • RTD Control Module
    • Removal & Installation
  • RTD Control Switch
    • Removal & Installation
  • RTD Position Sensor
    • Removal & Installation
  • Shock Absorber
    • Removal & Installation
  • RTD Relay
    • Removal & Installation
• Wiring Diagrams