Ignition Cycle Default Method
DTCs will be erased after 100 DTC free ignition cycles. RTD control module ignition cycle counter will reset to zero.
DIAGNOSTIC TROUBLE CODE DEFINITIONS
| DTC | Description |
|---|---|
| B2795 | Suspension Control Select Switch Circuit Malfunction |
| B3577 | Suspension Control Select Switch Contact Malfunction |
| C0550 | ECU Malfunction |
| C0563 | Calibration ROM Checksum Error |
| C0577 | Left Front Solenoid Circuit Low |
| C0578 | Left Front Solenoid Circuit High |
| C0579 | Left Front Solenoid Circuit Open |
| C0582 | Right Front Solenoid Circuit Low |
| C0583 | Right Front Solenoid Circuit High |
| C0584 | Right Front Solenoid Circuit Open |
| C0587 | Left Rear Solenoid Circuit Low |
| C0588 | Left Rear Solenoid Circuit High |
| C0589 | Left Rear Solenoid Circuit Open |
| C0592 | Right Rear Solenoid Circuit Low |
| C0593 | Right Rear Solenoid Circuit High |
| C0594 | Right Rear Solenoid Circuit Open |
| C0615 | Left Front Position Sensor Malfunction |
| C0620 | Right Front Position Sensor Malfunction |
| C0625 | Left Rear Position Sensor Malfunction |
| C0630 | Right Rear Position Sensor Malfunction |
| C0665 | Chassis Pitch Signal Circuit |
| C0690 | Damper Control Relay Circuit Malfunction |
| C0691 | Damper Control Relay Circuit Range |
| C0693 | Damper Control Relay Circuit High |
| C0695 | Position Sensor Overcuurent (8 Volt Supply) |
| C0710 | Steering Position Signal Malfunction |
| P1652 | Chassis Pitch Signal Malfunction |
| U1000 | Class 2 Communication Malfunction |
| U1255 | Class 2 Communication Malfunction |
| U1001-U1254 | Lost Communication |