LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Instrument Panel Trim And Console Trim >> Repair Instructions >> Instrument Panel Lower Trim Panel Replacement

Instrument Panel Lower Trim Panel Replacement

Fig 1: View Of Lower Instrument Panel (I/P) Trim Panel
GM1616960Courtesy of GENERAL MOTORS CORP.
Instrument Panel Lower Trim Panel Replacement

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Remove the instrument panel top pad. Refer to Instrument Panel Upper Trim Pad Replacement .
  2. Remove the instrument panel center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .
  3. Remove the instrument panel cluster assembly. Refer to Instrument Cluster Replacement .
  4. Remove the driver knee bolster assembly. Refer to Driver Knee Bolster Replacement .
  5. Remove the steering column. Refer to Steering Column Replacement .
  6. Remove the instrument panel compartment. Refer to Instrument Panel Compartment Replacement .
  7. Remove the instrument panel ashtray assembly, if equipped. Refer to Ashtray Replacement .
  8. Remove the center console, if equipped. Refer to Console Replacement .
  9. Remove the radio. Refer to Radio Replacement .
  10. Remove the HVAC control module. Refer to HVAC Control Module Replacement .
  11. Remove the instrument panel left air outlet. Refer to Air Outlet Replacement - Instrument Panel - Left .
  12. Remove the right and left side window air outlet ducts. Refer to Air Outlet Replacement - Side Window .
  13. Remove the instrument panel right air outlet. Refer to Air Outlet Replacement - Instrument Panel - Right .
1 Instrument Panel Lower Panel Bolts (Qty: 16)

Tighten:  9 N.m (80 lb in)

2 Instrument Panel Lower Panel Assembly
Tip: 
  1. Note the routing of the electric harness prior to removal of the lower panel assembly to aid in the reinstallation.
  2. Disconnect the electrical harness connections.