Installing radial shaft seal of manual transmission input shaft

• Coat sealing lips of radial shaft seal (1)  with transmission oil.
• Push radial shaft seal (1) onto the special tool 0 495 627 (23 3 240)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Slide special tool 0 495 627 (23 3 240)  onto the drive shaft.
• Drive in radial shaft seal with a plastic hammer up to the stop.

Courtesy of BMW OF NORTH AMERICA, INC.

• Install guide tube (1)  .
• Tighten down screws (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE CLUTCH OPERATOR .
• Refer to INSTALLING THE MANUAL TRANSMISSION (GS6L55TZ) .
• Refer to FASTENING THE PROP SHAFT (PARTIALLY REMOVED) .
• Refer to INSTALLING FRONT HEAT SHIELD .
• Refer to INSTALLING THE REAR HEAT SHIELD .
• Refer to INSTALLING THE LEFT THRUST FIELD .
• Refer to INSTALLING TANK COVER .
• Refer to INSTALLING TRANSMISSION CROSS MEMBER .
• Refer to INSTALLING EXHAUST SYSTEM .
• Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
• Refer to INSTALLING THE OXYGEN SENSOR MONITOR FOR CYLINDERS 4 TO 6 .
• Refer to PARTIALLY INSTALLING THE COOLANT EXPANSION TANK OF THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING THE RIGHT INTAKE FILTER HOUSING (FRONT-END STRUT REMOVED) .
• Refer to CHECKING/ADDING TO THE OIL LEVEL IN THE MANUAL TRANSMISSION (GS6L55TZ) .
• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to INSTALLING THE LEFT AND RIGHT FRONT UNDERSHIELD .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .
• Refer to INSTALLING THE FRONT SPOILER .
• Refer to INSTALLING THE FRONT-END STRUT .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE STRUT BRACE .
• Refer to TAKING HOOD OUT OF THE SERVICE POSITION .