Installing the acoustic cover for the oil pan
- Install acoustic cover (1)
to the top front.
- Secure all expanding rivets (1)
.
- Connect connectors (1) and lock.
- Make sure the connector (1) engages audibly.
- Insert and install the positive battery cable (3) .
- Secure positive battery cable (3) at the clamp (4) .
- Tighten the nut (2)
hand-tight.
CAUTION:
Improper routing of the positive battery cable.
Risk of short circuits!
Risk of short circuits!
- Route the positive battery cable without abrasions and do not trap.
- Attach the positive battery cable 1 correctly to anti-twist lock (2) .
- Tighten nut (3)
.TIGHTENING TORQUES SPECIFICATION
Battery positive lead to starter M8 Tightening torque 13.5 Nm
Follow-up work
- Refer to RAISING THE FRONT AXLE SUPPORT AND FASTENING IT .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT TO THE ANTI-ROLL BAR .
- Refer to CONNECTING THE CONNECTOR ON THE RIDE HEIGHT SENSOR AT THE FRONT .
- Refer to FASTENING WIRING HARNESS TO THE EPS .
- Refer to SECURING THE STEERING SHAFT AT THE BOTTOM ON THE STEERING GEAR .
- Refer to FASTENING THE COOLANT LINE .
- Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to INSTALLING COVERS AT FRONT BOTTOM ON LEFT AN RIGHT SIDES .
- Refer to REMOVING THE ENGINE FROM THE INSTALLATION POSITION .
- Refer to INSTALLING THE CLEAN AIR PIPE WITH THE RESONATOR .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to ACTIVATING VEHICLE-SPECIFIC HIGH-VOLTAGE OR LOW-VOLTAGE VEHICLE ELECTRICAL SYSTEM .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .