Removing the engine from the installation position
- Lower engine by turning the spindle 2 361 506 (00 6 103)
until the engine lies completely on the engine supports.
- Feed out the hook 1 0 496 733 (00 6 080) from then special tool 2 459 012 and place it to the side.
NOTE:
TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.
Conduct the following operation with the assistance of a second person.
- Remove the engine bridge (1)
with a support person.
- Tighten bolt (1) of the left engine mount from the bottom using a standard tool.
TIGHTENING TORQUES SPECIFICATION
| Engine mount to engine support bracket | ||
| M12 Replace the screw and clean the thread on the engine mount. |
Tightening torque | 110 Nm |
- Tighten bolt (1) of the right engine mount from the top using a standard tool.
TIGHTENING TORQUES SPECIFICATION
| Engine mount to engine support bracket | ||
| M12 Replace the screw and clean the thread on the engine mount. |
Tightening torque | 110 Nm |
- Unscrew the bolts (1) of the special tool 2 459 012 .
- Feed out the special tool 2 459 012 at the cylinder head and remove.
Follow-up work
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE CLEAN AIR PIPE WITH THE RESONATOR .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .