Installing the headlining (lowered)
- Remove the upholstery (2) from the headlining (1).
- Check the clips (1) on the headlining (2) for damage and replace, if necessary.
- Correctly position the headlining (1) with the help of a support person and feed in on the respective edge protection.
- Clip in the headlining (2) using the clips (1).
- Clip in the headlining (1) using the clips (2).
Check
- Check clips (1) on the trim (2) for damage and replace, if necessary.
- Check the detent (3) on the trim (2) for damage.
Result
Detent is damaged.
Measure
- Replace cover of the auxiliary brake light (2).
- Fit the cover of the auxiliary brake light (1) from the bottom.
- Clip in the cover of the auxiliary brake light (1) with the clips (3) and the detent (2).NOTE: Perform the steps on the right and left side.
- Fasten the expanding rivet (1) on the headlining (2).
Follow-up work
- Refer to INSTALLING INTERIOR ROOF LIGHT .
- Refer to INSTALLING THE GRAB HANDLE AT THE REAR LEFT AND RIGHT .
- Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
- Refer to INSTALLING THE LEFT AND RIGHT FRONT VANITY MIRROR LIGHT .
- Refer to INSTALLING BOTH SUN VISORS AND COUNTER SUPPORTS .
- Refer to INSTALLING THE LEFT AND RIGHT HANDS-FREE MICROPHONE .
- Refer to INSTALLING THE C-PILLAR TRIM PANEL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE LEFT AND RIGHT SEAT BELT FINISHER STRIP .
- Refer to INSTALLING BOTH BACKREST SIDE SECTIONS .
- Refer to PARTIALLY INSTALLING BOTH B-PILLAR TRIM PANELS AT TOP .
- Refer to INSTALLING A-PILLAR TRIM PANEL, LEFT AND RIGHT .