Install the oil vacuum pump

Feed oil vacuum pump (1) in the drive chain (2) and position.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace screws (1) .
Parts: Screws
Tighten the screws (1) .

TIGHTENING TORQUE SPECIFICATION

Oil vacuum pump to crankcase
M8 Replace screw.	1. Joining torque	15 Nm
	2. Angle of rotation	45°

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to REFITTING ENGINE OIL PAN .
Refer to INSTALLING STARTER MOTOR .
Refer to INSTALLING THE ACOUSTIC COVER FOR THE OIL PAN .
Refer to INSTALLING THE HOLDER FOR THE THERMOSTAT ON THE TRANSMISSION OIL LINES .
Refer to INSTALLING THE THERMOSTAT ON THE TRANSMISSION OIL LINES .
Refer to RAISING THE FRONT SUBFRAME .
Refer to PARTIALLY INSTALLING THE AIR DUCT FOR THE BRAKE ON THE LEFT AND RIGHT .
Refer to ATTACHING THE ANTI-ROLL BAR LINK ON THE ANTI-ROLL BAR AT LEFT AND RIGHT .
Position the line.
Clip the line into the bracket (2).

Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.
Refer to SECURING THE WIRING HARNESS FOR THE EPS ON THE FRONT AXLE SUPPORT .
Refer to SECURING THE STEERING SHAFT AT THE BOTTOM ON THE STEERING GEAR .
Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER .
Refer to INSTALLING THE LOWER WHEEL ARCH COVER ON THE LEFT AND RIGHT .
Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
Refer to REMOVING THE ENGINE FROM THE INSTALLATION POSITION .
Refer to FASTENING THE WIRING HARNESS SECTION TO THE LEFT SHOCK TOWER .
Refer to FASTENING THE WIRING HARNESS SECTION TO THE RIGHT SHOCK TOWER .
Refer to INSTALLING THE SIDE PANEL SEAL .
Refer to INSTALLING THE LATERAL HOOD SEALS .
Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
Refer to INSTALLING THE CLEAN AIR PIPE WITH THE RESONATOR .
Refer to TOPPING UP THE MOTOR OIL .
Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
Refer to CHECKING ENGINE OIL LEVEL .
Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
Refer to INSTALLING ACOUSTIC COVER .
Refer to INSTALLING FRONT UNDERBODY PROTECTION .
Refer to IF INSTALLED: INSTALL UNDERBODY PROTECTION FOR THE STEERING .
Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR .
Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
Refer to TAKING HOOD OUT OF THE SERVICE POSITION .