Installing the clean air pipe with the resonator

• Check the seal (1) for damage and replace if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

  • Replacing the damaged seal 
  NOTE: TECHNICAL INFORMATION 
  Use of sharp or pointy tools for installation or removal is prohibited.
• Remove damaged seal.
• Clean the gasket groove (1) with a dry cloth.

  The gasket groove (1) must be clean.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace gasket.

  Parts:  Gasket

• Install the seal dry without lubricant or mounting agent.
  NOTE: TECHNICAL INFORMATION 
  Incorrect assembly is possible. Ensure correct installation position.
• Thread in seal and install.
• Make sure that the seal is installed correctly in the gasket groove (1).
• Make sure that the sealing lip (2) is directed to the inside as shown.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Version A: 
• Guide in and install the clean air pipe with resonator (3).
• Lock clamp (2).

  Clamp (2) must engage audibly.

• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

• Secure clamp (arrow).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Press the clean air pipe with resonator (1) in the arrow direction and hold it.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock tank vent line (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Version B: 
• Install the clean air pipe with resonator (1) and connect it.

  The clean air pipe with resonator (1) must snap in audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Lock clamp (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect line (3).

  Line (3) must engage audibly.

• Secure clamps (2).
• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the clean air pipe with resonator to the intake filter housing.
• Tighten clamp (3).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Clean air pipe to upper section of intake filter housing
  cl.	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure the clamp (2).
• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

• Insert and install the engine ventilation line (2)  .
• Ensure that locks (1) engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING ACOUSTIC COVER .