Installing front propeller shaft at the front axle transmission
- Before installing the prop shaft on the front axle transmission, all the 4 threads (1)
in the drive flange must be cleaned and free from possible residues and contaminations.
- Replace screws.
Parts: Screws
- A drop of Loctite 270 (2)
must be given before the screw connection on each thread at the end of the respective screw (1)
.CONSUMABLE SPECIFICATION
Loctite 270 high-strength thread lock 10 ml, Tube 83 19 2 210 337 NOTE: TECHNICAL INFORMATION
After the screw connection of the front prop shaft, a 30 minute hardening time must be ensured before the vehicle is operated again. - Tighten screws (arrows).
TIGHTENING TORQUES SPECIFICATION
| Prop shaft before the front axle differential | ||
|---|---|---|
| Replace screws. Joining torque and angle of rotation must be observed without fail. Clean thread on front axle differential using a thread cutter. |
Snug torque | 25 Nm |
| Angle of rotation | 45° | |
Follow-up work
- Refer to INSTALLING THE TRANSFER BOX (ATC 13-1) .
- Refer to FASTENING THE PROP SHAFT (PARTIALLY REMOVED) .
- Refer to INSTALLING TRANSMISSION CROSS MEMBER .
- Refer to INSTALLING THE HEAT SHIELDS .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to REMOVING UNDERBODY PROTECTION AT SIDE RIGHT AND LEFT .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING EXHAUST SYSTEM .
- Refer to INSTALLING THE REAR TUNNEL CONNECTING SUPPORT .
- Refer to INSTALLING THE REINFORCEMENT STRUT .
- Refer to INSTALLING THE REAR DIFFUSER .
- Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
- Refer to ACTIVATING VEHICLE ELECTRICAL SYSTEM .