Installing transmission cross member
- Install the transmission cross member (3) .
- Tighten down screw (1) .
TIGHTENING TORQUES SPECIFICATION
| Transmission cross member to rubber mounts | ||
| M12 | tightening torque | 68 Nm |
- Tighten down screws (2) .
TIGHTENING TORQUES SPECIFICATION
| Transmission cross member to body | ||
| M8 | Tightening torque | 19 Nm |
- Release the luggage strap (1) from the transmission.
- Remove the special tools 0 495 498 (23 4 050) and 2 219 012 .
Follow-up work
- Refer to REMOVING THE TRANSMISSION JACK .