11 34 552 Removing and installing or replacing all valves (cylinder head removed): Notes
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to INSTALLING THE CYLINDER HEAD ON THE SPECIAL TOOL
- Refer to REMOVING THE EXHAUST TURBOCHARGER (CYLINDER HEAD REMOVED)
- Refer to REMOVING EXHAUST TURBOCHARGER TRIM STRIP
- Refer to INSTALLING THE CYLINDER HEAD ON THE SPECIAL TOOL (turbocharger removed)
- Refer to CHECKING THE POSITION OF THE INTAKE CAMSHAFT (cylinder head removed)
- Refer to CHECKING THE POSITION OF THE INTAKE CAMSHAFT AT CYLINDERS 3 AND 4 (cylinder head removed)
- Refer to REMOVING TORSION SPRINGS
- Refer to REMOVING ALL GATES
- Refer to REMOVING ALL INTERMEDIATE LEVERS
- Refer to REMOVING INTAKE CAMSHAFT
- Refer to REMOVING THE SERVOMOTOR FOR THE ECCENTRIC SHAFT
- Refer to REMOVING ECCENTRIC SHAFT
- Refer to REMOVING EXHAUST CAMSHAFT
- Refer to REMOVING ALL ROLLER CAM FOLLOWERS
- Refer to REMOVING VALVE SPRINGS
- Refer to REMOVING VALVE STEM SEALS
Follow-up work
- Refer to INSTALLING VALVE STEM SEALS
- Refer to INSTALLING VALVE SPRINGS
- Refer to INSTALLING ALL ROLLER CAM FOLLOWERS
- Refer to INSTALLING EXHAUST CAMSHAFT ADJUSTER
- Refer to INSTALLING ECCENTRIC SHAFT
- Refer to INSTALLING SERVOMOTOR FOR THE ECCENTRIC SHAFT
- Refer to INSTALLING INTAKE CAMSHAFT
- Refer to CHECKING INSTALLATION POSITION OF ROLLER CAM FOLLOWERS
- Refer to CHECKING THE INTERMEDIATE LEVER CLASSIFICATION
- Refer to INSTALLING ALL INTERMEDIATE LEVERS
- Refer to INSTALLING ALL GATES
- Refer to CHECKING THE POSITION OF THE INTAKE CAMSHAFT (cylinder head removed)
- Refer to CHECKING THE POSITION OF THE INTAKE CAMSHAFT AT CYLINDERS 3 AND 4 (cylinder head removed)
- Refer to INSTALLING TORSION SPRINGS
- Disassemble cylinder head from the special tool (turbocharger removed)
- Refer to INSTALLING THE TRIM STRIP FOR THE EXHAUST TURBOCHARGER
- Refer to INSTALLING THE EXHAUST TURBOCHARGER (CYLINDER HEAD REMOVED)
- Assemble the cylinder head. Refer To INSTALLING ALL VALVES .