REP-TAT-P-1137-02 Installing servomotor for the eccentric shaft

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Detach gasket (1) and replace.

Parts: Gasket

Courtesy of BMW OF NORTH AMERICA, INC.

Press in gasket (1) up to stop on housing of the servomotor.

Courtesy of BMW OF NORTH AMERICA, INC.

Clean sealing surface (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Insert servomotor (1) till the gearing is lined up.
Turn the servomotor (1) in the marked area to the right with conventional tools until it rests against the cylinder head.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

TIGHTENING TORQUES SPECIFICATION

Servomotor for the eccentric shaft to cylinder head
M6 x 16	tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Lock connector (2).
Position the ventilation line (1) on the intake plenum and lock.

Courtesy of BMW OF NORTH AMERICA, INC.