REP-TAT-P-1137-05 Check the position of the intake camshaft at cylinder 3 and 4
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
Check
- Check the position of the intake camshaft at cylinder 3 and 4.
To remove the torsion springs on cylinders 3 and 4, the camshaft sensor wheel 1 of the intake camshaft must be in the position shown.
Result
The camshaft sensor wheel 1 of the intake camshaft is not in the position shown.
Measure
- Turn engine on the vibration damper using special tool 0 493 380 (11 6 480) until the camshaft sensor wheel 1 of the intake camshaft is in the position shown.
Check
- Check the position of the intake camshaft at cylinder 3 and 4.
To remove the torsion springs on cylinders 3 and 4, the camshaft sensor wheel 1 of the intake camshaft must be in the position shown.
Result
The camshaft sensor wheel 1 of the intake camshaft is not in the position shown.
Measure
- Turn engine on the vibration damper using special tool 0 493 380 (11 6 480) until the camshaft sensor wheel 1 of the intake camshaft is in the position shown.