REP-TAT-P-1136-02 Install exhaust camshaft adjuster

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Exhaust camshaft adjuster

Courtesy of BMW OF NORTH AMERICA, INC.

Overview graphic of the VANOS central valves

8 617 694 - Short VANOS central valve

7 620 689 - Long VANOS central valve

8 695 709 - VANOS central valve (increased leakage) (TZV)

8 696 446 - VANOS central valve (low leakage) (TZV

NOTE: After replacing one or more VANOS central valves or VANOS adjusters:
When removing, make note of the identification/part number of the VANOS central valve or VANOS adjuster and consider writing it down.
It must be replaced with a VANOS adjuster or VANOS central valve with the same part number. A mixed installation is not allowed.
Read out the vehicle I-level and proceed accordingly.
Be absolutely certain to pay attention to PuMA measure 64122020.
For further information, see the applicable BMW Parts Catalogue.

Lay out the exhaust camshaft adjuster marked with EX (arrow).

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in exhaust camshaft adjuster (1) in the timing chain (2) and position on the exhaust camshaft (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Abut VANOS central valve (1) of exhaust side.

Courtesy of BMW OF NORTH AMERICA, INC.