11 12 000 Removing and installing/sealing cylinder head cover: Notes
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work:
- Disconnect all battery ground leads
- Refer to REMOVING THE ACOUSTIC COVER
- Refer to REMOVING INTAKE SILENCER HOUSING
- Refer to REMOVING CLEAN AIR PIPE
- Refer to REMOVING FAN COWL .
- Remove the cover in the left engine compartment
- Remove the right cover in the engine compartment
- Remove the sound insulation on the bulkhead upper part center
- Remove both wiper arms
- Remove cowl panel cover
- Refer to REMOVING TRAILING LINK AT SPRING STRUT DOME
- Refer to REMOVING ACOUSTIC COVER AT REAR
- Remove ignition coils. Refer to REPLACING IGNITION COILS .
- Refer to REMOVING THE HIGH PRESSURE LINE BETWEEN THE RAIL AND THE HIGH PRESSURE PUMP
- Refer to REMOVING FUEL DELIVERY LINE
- Refer to REMOVING THE INJECTORS FOR CYLINDERS 1 TO 3
- Refer to REMOVING THE INJECTORS FOR CYLINDERS 4 TO 6
- Refer to REMOVING HIGH PRESSURE PUMP
- Refer to REMOVING BOTH ACTUATORS
- Refer to REMOVING FRONT ENGINE ENCAPSULATION
Follow-up work:
- Refer to INSTALLING FRONT ENGINE ENCAPSULATION
- Refer to INSTALLING BOTH ACTUATORS
- Refer to PREPARING FOR THE INSTALLATION OF THE HIGH PRESSURE PUMP
- Refer to INSTALLING HIGH PRESSURE PUMP
- Refer to PREPARING THE INJECTORS FOR INSTALLATION
- Refer to INSTALLING THE INJECTORS FOR THE CYLINDERS 1 TO 3
- Refer to INSTALLING THE INJECTORS FOR THE CYLINDERS 4 TO 6
- Refer to INSTALLING FUEL DELIVERY LINE
- Refer to INSTALLING THE HIGH-PRESSURE LINE BETWEEN THE HIGH-PRESSURE RAIL AND THE HIGH-PRESSURE PUMP
- Refer to INSTALLING THE IGNITION COILS
- Refer to INSTALLING ACOUSTIC COVER AT REAR
- Install tension strut on spring strut dome. Jointing torque: 56 Nm, angle of rotation: 90° NOTE: Replace screws.
- Attach cowl panel cover
- Install both wiper arms
- Check the angle of attack of the wiper arms on the left and right
- Install the sound insulation on the bulkhead upper part center
- Install the cover in the engine compartment on the left
- Install the cover in the engine compartment on the right
- Refer to INSTALLING FAN COWL
- Refer to INSTALLING CLEAN AIR PIPE
- Refer to INSTALLING INTAKE SILENCER HOUSING
- Refer to INSTALLING ACOUSTIC COVER
- Connect all battery ground leads