REP-TAT-P-1136-02 Installing both actuators

• Check seal (1) for damage and, if necessary, replace actuator (2).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The figure shows the rear of the engine.

• Position both actuators.
• Connect and lock both connectors (1).
• Make sure the connectors (1) engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The figure shows the rear of the engine.

• Position special tool 2 360 895  correctly on the actuator (1) of the exhaust side.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the actuator (1) of the exhaust side and turn in the arrow direction with the special tool 2 360 895  until the limit stops tap the clamps.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The figure shows the rear of the engine.

• Position special tool 2 360 895  correctly on the actuator (1) of the intake side.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the actuator (1) of the intake side and turn in the arrow direction with the special tool 2 360 895  until the limit stops tap the clamps.

Courtesy of BMW OF NORTH AMERICA, INC.